Packard Bell MH4000 manual SCSISelect Utility, Exiting Bios Setup

4-17

Exiting BIOS Setup

To exit Setup, select Exit from the menu bar to display the Exit Setup menu.

The following table describes the options on this menu. Note that ESC does not exit this menu. You must select one of the items from the menu or menu bar to exit this menu.

SELECTION	DESCRIPTION
Save changes and	Stores the selections displayed in the menus in
Exit	CMOS and exits the Setup program.
Exit without Saving	Exits the program without saving any changes you
Changes	have made in this session. Previous selections
	remain in effect.
Get Default Values	Displays default values for all Setup menus. Useful
	if BIOS detects a problem with the values stored in
	CMOS.
Load Previous	Reverts to previously saved values if the new
Values	values have not been saved to CMOS.
Save Changes	Stores the current selections without exiting the
	Setup program.

SCSISelect Utility

Your system board includes two integrated SCSI host controllers used to manage SCSI devices in your system. The AIC7880 wide SCSI controller provides support for four internally mounted ultra/wide hard disk drives. The AIC7860 narrow SCSI controller provides support for internally mounted tape and CD- ROM devices as well as externally connected SCSI devices.

The integrated SCSI host controllers are configured using the SCSISelect utility. Use the SCSISelect utility to:

■Change the SCSI host adapters default values.

■Check and/or change SCSI device settings for a particular device.

■Perform low-level formatting on SCSI disk devices.

■Perform verify operations on SCSI disk devices.

Configuring Your System