Note: SCSI termination is automatic and requires no user configuration.
15Turn on the power to the DEU. After the
16Access the Options menu on the Operator Control Panel and choose the SAFTE CHAIN ID selection. Refer to “SAFTE CHAIN ID” earlier in this Guide.
17After setting the cabinet identifications you must power cycle the subsystems. Observe normal power cycling precautions by waiting a minimum of five seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID conflict under normal conditions, refer to “Default Configurations” later in this section.
18Power up your computer system and run the configuration program.
This completes the setup and configuration.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
