TOP Master | TOP Slave #1 |
meters)(3
CableData
Ultra SCSIWide
Chl #0 | Chl #1 |
| ModuleBus |
Chl #0 | Chl #1 |
Extender Card | Extender Card |
I/O Interface Card
I/O Interface Card
Chl #0 | Chl #1 |
| ModuleBus |
Chl #0 | Chl #1 |
Ultra Wide SCSI | Chl #1 |
Controller |
|
Host Computer #1
1 meter Ultra Wide SCSI Jumper
Available Drive
Unavailable Drive
6Connect one end of a 3 meter data cable to the Channel #1 connector on the RAID Controller.
7Connect the other end of the data cable to the Channel 1 connector on the upper or right side single channel Ultra Extender Option card installed in the master cabinet.
8Connect one end of a 1 meter jumper cable to the Channel 0 connector on the lower or left side I/O Interface card in the master cabinet.
9Connect the other end of the 1 meter jumper cable to the Channel 1 connector on the upper or right side single channel Ultra Extender Option card installed in the Slave #1 cabinet.
Note: SCSI termination is automatic and requires no user configuration.
10Power on the DEU subsystems. After the
11Access the Options menu on the Operator Control Panel and choose the SAFTE CHAIN ID selection. Set the cabinet identities of the master and slave subsystems. Refer to “SAFTE CHAIN ID” described earlier in this Guide.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
