Packard Bell ST8000, 5800 manual

Populate drive bays from the lower (right) slot first.

Drive Label

Upper (left) bay, four drive slots

	Lower (right) bay,
Component side	four drive slots

Single-Bus module: Begin populating the drive with the far right slot or lowest slot and work to your left or up.

6Fully seat the drive by applying light pressure with your thumb to the front of the drive.

7Press the Drive Latching Clips until they ‘snap ‘ into place. The drive is now locked into position.

8Install the remaining drives repeating steps 3 through 7, until all the drives have been installed, as desired.

Note: Verify that the power switch on the DEU is in the OFF position (O).

9Connect one end of the power cord to the power connector on the rear panel and the other end to a three-hole grounded outlet or power strip. A UPS is recommended.

10Refer to the Cabling Configuration section and follow the procedures to cable your system.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.