Packard Bell ST8000, 5800 manual JP3 SCSI-to-SCSI IDs, JP4 Scsi ID Settings

JP3 (SCSI-to-SCSI IDs)

Caution: Jumper configuration to be performed by qualified service personnel only.

These jumpers (JP3) are used to manually set the SCSI- TO-SCSI IDs for the SCSI-to-SCSI RAID controller. JP3 is an four position dual-row header.

JP3

			8		S2S
					SCSI
					1 IDs
	Jumper Positions
1 & 2		3 & 4	5 & 6	7 & 8		SCSI-to-SCSI ID Settings
ON		ON	ON	ON		15
OFF		ON	ON	ON		14
ON		OFF	ON	ON		13
OFF		OFF	ON	ON		12
ON		ON	OFF	ON		11
OFF		ON	OFF	ON		10
ON		OFF	OFF	ON		9
OFF		OFF	OFF	ON		8
ON		ON	ON	OFF		7
OFF		ON	ON	OFF		6
ON		OFF	ON	OFF		5
OFF		OFF	ON	OFF		4
ON		ON	OFF	OFF		3
OFF		ON	OFF	OFF		2
ON		OFF	OFF	OFF		1
OFF		OFF	OFF	OFF		0

JP4 (SCSI ID Settings)

Caution: Jumper configuration to be performed by qualified service personnel only.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.