SET LOWER SLOT IDS |
|
|
|
|
SET UPPER SLOT IDS |
|
|
|
|
SET RAID MODULE ID |
|
|
|
|
SET SAFTE ID | 0 | 1 | 2 | 3 |
LOWER 4 | 0 | 1 | 2 | 4 |
| 4 | 5 | 6 | 7 |
| 4 | 5 | 6 | 8 |
| 5 | 6 | 7 | 8 |
MENU ENTER ESCAPE
MENU ENTER ESCAPE
Reset Default IDs Selection
Choosing the “Reset Default Ids” option will automatically set the SCSI IDs to IDs 0, 1, 2, and 4 for the drives, and ID 3 for the processor. SCSI ID values for the drives will be the same for both SCSI bus channels.
If an Ultra S2S RAID Controller is installed the SCSI
ID will automatically be set to ID # 0.
SET UPPER SLOT IDS
SET RAID MODULE ID
SET SAFTE ID
RESET DEFAULT IDS | ALL SCSI IDS SET |
TO
MENU ENTER ESCAPE 
MENU ENTER ESCAPE 
Note: When the “Reset Default Ids” is selected or anytime you change a SCSI ID setting, you must power the DEU OFF and ON at that screen for those settings to take effect. Be sure to power OFF the host computer prior to cycling the power on the DEU. Otherwise, the PCI RAID Controller (if used) will “kill” all drives in the array.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
