Packard Bell ST8000, 5800 manual Heat Threshold, Safte Chain ID

Heat Threshold

Note: The Heat Threshold value is pre-set at the factory and should not be changed unless directed by Technical Support. The default setting is 114°F/45°C.

Choose the Heat Threshold Menu to change the temperature value for the temperature monitoring system. If the temperature exceeds the value set here, a “Temperature Threshold Exceeded” screen will appear, see Internal Temp described earlier.

SCSI ID MENU

HEAT THRESHOLD

SAFTE CHAIN ID

CHANGE PASSCODE

MENU ENTER ESCAPE

ARROWS TO CHANGE

ENTER TO SET

ESC TO EXIT

114 F / 45 C

MENU ENTER ESCAPE

SAFTE CHAIN ID

This option allows the administrator to establish the intercabinet SAF-TE communication to support a master and slave cabinets. The master cabinet can report component failure for both the master cabinet and up to two slave cabinets to the RAID management software. Each cabinet’s individual OCP will function normally for that cabinet’s components.

Once the slave cabinets have been established, the administrator must use the slave cabinet’s OCP to manually take that slave cabinet SAF-TE card off bus, refer to “Manual ID Selection” described earlier.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.