7After setting the cabinet identifications you must power cycle the subsystem. Observe normal power cycling precautions by waiting a minimum of five (5) seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID conflict under normal conditions.
8Power up your computer system and run the configuration program.
This completes the hardware installation.
Single - Bus Cabinet
The
The SCSI IDs of the drives are set by
Note: SCSI ID 3 is reserved for the
Caution: Ensure that the power switch is in the OFF
(O)position for both the host system and the DEU subsystem before connecting any cables.
1Connect one end of a one meter data cable to the Channel #1 connector on the Host Controller.
2Connect the other end of the data cable to the Channel 1 SCSI connector on the upper or right side I/O Interface card.
Note: The Channel 1 connector located on the upper or right side I/O Interface card is the active connector when the
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.