Packard Bell 5800, ST8000 manual Repeat steps 5 and 6 for the second Slave #2 cabinet

6Install a two-channel Ultra Extender Option card into the upper or right side card slot and tighten the thumb screws.

Ultra Extender

Option Card

I/O Interface Card

7Repeat steps 5 and 6 for the second (Slave #2) cabinet.

1 meter Ultra Wide SCSI Jumper

			1 meter Ultra Wide SCSI Jumper
TOP Master				TOP Slave #1
Chl #0		Chl #1		Chl #0	Chl #1
			I/O Interface Card
			SAF-TE Card
			1-CH Ultra
			Extender Card
		ModuleBus -Dual	SAF-TE Card		ModuleBus -Single
			I/O Interface Card
Differential SCSI	Chl #0	Chl #1	2-CH Differential	Chl #0	Chl #1
Data Cable (25 meters)
			Converter Card

Chl #1

Differential SCSI

Host Adapter Chl #2

Host Computer #1 Differential SCSI Data Cable (25 meters)

TOP Slave #2

Chl #0	Chl #1
1-CH Ultra
Extender Card
SAF-TE Card
	ModuleBus -Single
I/O Interface Card
Chl #0	Chl #1

Note: Secure the cable connectors using the thumb screws (finger tight only).

8Connect one end of a 25 meter data cable to the Channel #1 connector on the differential host adapter.

9Connect the other end of the data cable to the Channel 0 connector on the lower or left side 2- channel Differential Converter card installed in the master cabinet.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.