Packard Bell 5800, ST8000 manual Default Configurations

Default Configurations

The following table provides the default SCSI ID settings that will be set by subsystem processor when a specific configuration is chosen in the OCP Menu option SAFTE CHAIN ID setting.

	Master	Master	Slave 1	Slave 1	Slave 2	Slave 2
	Cabinet -	Cabinet -	Cabinet -	Cabinet -	Cabinet -	Cabinet -
	Single-Bus	Dual-Bus	Single-Bus	Dual-Bus	Single-Bus	Dual-Bus
	Mode	Mode	Mode	Mode	Mode	Mode
	9	4	13	9	13	13
Upper
	8	2	12	8	12	12
Bay
	6	1	11	6	11	11
	5	0	10	5	10	10
	4	4	9	9	9	13
Lower
	2	2	8	8	8	12
Bay
	1	1	6	6	6	11
	0	0	5	5	5	10

When two single-bus cabinets are installed as a Master and a Slave system, two drive slots will be unavailable to the controller. Under this condition you will be required to manually configure these IDs setting. The two upper bay disk drive slots on the Slave system should be set with the ID setting of “XX.” These two drive slots will then be taken off bus.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.