Note: SCSI termination is automatic and requires no user configuration
16Power on the DEU subsystems. After the
17Access the Options menu on the Operator Control Panel and choose the SAFTE CHAIN ID selection. Set the cabinet identities of the master and slave subsystems. Refer to “SAFTE CHAIN ID” in the DEU User’s Guide.
18After setting the cabinet identifications you must power cycle the subsystems. Observe normal power cycling precautions by waiting a minimum of five seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID conflict under normal conditions, refer to “Default Configurations” later in this section.
19Power up your computer system and run the configuration program.
This completes the setup and configuration.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
