2Locate the two support brackets. Mount the two brackets to the rack cabinet verticals using the four screws, two washers, and caged nuts provided. The bracket has a slotted hole and a countersunk hole. Mount the slotted hole on the rear vertical. The slotted hole receives a “pan head” screw with a washer and the countersunk hole receives a “flat head” screw.
Note: The caged nuts are secured into the rack cabinet vertical slots by inserting one side of the nut into the slot and squeeze while pressing the opposite side until it snaps into place.
3Install the caged nuts that will secure the front bezel in step (6) prior to inserting the DEU into the rack assembly.
4Locate the two “D” handle assemblies.
aPosition a handle assembly on each handle mounting bracket located on the sides of the cabinet. The handles are universal and will fit either side.
bSecure the handles with the two screws provided.
5Lift the DEU up and onto the support brackets previously installed in step 2. Slide the DEU toward the rear of the rack cabinet.
6Secure the front bezel to the rack verticals using the four screws and plastic washers provided.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
