Note: Shielded data cables, such as those provided with the subsystem, must be used to prevent radio frequency interference. It is recommended that you use the cables provided with your system. These cables have been tested and meet stringent guidelines set forth by
Ultra Wide SCSI Mode
Several possible configurations exist for the DEU in Ultra Wide SCSI mode. However this manual will discuss the two possible configurations using the I/O Interface card in Ultra Wide SCSI mode:
Note: When configuring a
Dual - Bus Cabinet
This configuration provides two separate SCSI bus connections to the drives.
From the front, the drives slots are divided into two banks. The left or upper four front drive slots, which are connected to “Channel 1” on the I/O Interface card, and the right or lower four front drive slots are connected to “Channel 0” on the I/O Interface card.
The SCSI IDs of the drives are set by
Note: SCSI ID 3 is reserved for the
Caution: Ensure that the power switch is in the OFF
(O)position for both the host system and the DEU subsystem before connecting any cables.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.