12After setting the cabinet identifications you must power cycle the subsystems. Observe normal power cycling precautions by waiting a minimum of five seconds before adding power again.
This will reset the SCSI IDs to a default setting that prevents a SCSI ID conflict under normal conditions, refer to “Default Configurations” later in this section.
13Power up your computer system and run the configuration program.
This completes the setup and configuration.
Two Dual - Bus Cabinets
With this configuration you will have up to eight (8) disk drives per controller channels. If you are using multiple RAID Controllers you can further expand your capacity by using up to four controllers per CPU system.
1Power off your computer system or workstation.
2Be sure to complete the “Setup” and “Component Installation” sections described earlier in this Guide. The DEU ships from the factory with I/O Interface cards installed in both card slots. Therefore during installation, you may be required to remove one or both I/O Interface cards.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
