
SCSI ID MENU
HEAT THRESHOLD
SAFTE CHAIN ID
CHANGE PASSCODE
MENU ENTER ESCAPE
Manual ID Selection
SET LOWER SLOT IDS
SET UPPER SLOT IDS
SET RAID MODULE ID
SET SAFTE ID
MENU ENTER ESCAPE
You can set SCSI IDs manually for each group of devices from a
Note: SCSI ID #7 should not be used when a Ultra S2S
RAID Controller is installed.
When selecting IDs manually, SCSI ID 3 is normally used by the DEU processor. The SAFTE card ID may use the setting “OB” which indicates Off Bus. However, if SAFTE is off bus, LEDs and other error reporting will not function properly.
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.