LED Status | Reason | Solution |
|
|
|
Status Indicator LEDs | SCSI data cable not properly | Verify that the SCSI data cable is |
not functioning properly. | connected. | properly connected to the DEU |
|
| connector and to the controller card. |
|
|
|
A specific drive’s Status | An assigned drive has failed. The | Replace the disk drive and begin |
LED is blinking amber | DEU is in a | rebuilding the array, see Replacing a |
and the Channel Mode |
| Disk Drive described earlier in this |
LED is steady amber. |
| guide. |
|
|
|
A specific drive’s Status | An assigned drive has failed. The | Replace the failed disk drive (Drive’s |
LED is blinking amber, | DEU is in a | Status LED blinking amber). |
the remainder of the | and a rebuild operation is in |
|
drive’s Status LEDs in | progress. |
|
that array are steady |
|
|
amber, and the |
|
|
Channel Mode LED is |
|
|
steady amber. |
|
|
|
|
|
A specific drive’s Status | The disk drive is missing. The DEU | Insert a disk drive and begin an array |
LED is OFF and the | is in a | rebuild, see Replacing a Disk Drive |
Channel Mode LED is |
| described earlier in this guide. |
steady amber. |
|
|
|
|
|
A specific drive’s Status | A drive has not been assigned into | Assign the drive to an array, refer to the |
LED is blinking green | an array or the drive is a hot spare, | Ultra S2S RAID Controller User’s Guide. |
and the Channel Mode | however it is in a ready state. |
|
LED is steady green. |
|
|
|
|
|
PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.
