Packard Bell 5800, ST8000 manual SCSIDifferential CableData meters25

7Connect one end of a 25 meter data cable to the Channel #1 connector on the differential host adapter.

SCSIDifferential CableData meters)(25

Differential SCSI Host Adapter Chl #1

Host Computer #1

	TOP Master		TOP Slave #1
Chl #0	Chl #1	Chl #0	Chl #1
	1-CH Differential	1-CH Ultra
	Converter Card	Extender Card
	SAF-TE Card	SAF-TE Card
	ModuleBus -Single		ModuleBus -Single
	I/O Interface Card	I/O Interface Card
Chl #0	Chl #1	Chl #0	Chl #1
	1 meter Ultra Wide SCSI Jumper

Available Drive

Unavailable Drive

8Connect the other end of the data cable to the Channel 1 connector on the upper or right side single-channel Differential Converter Option card installed in the master cabinet.

9Connect one end of a 1 meter jumper cable to the Channel 0 connector on the lower or left side I/O Interface card in the master cabinet.

10Connect the other end of the 1 meter jumper cable to the Channel 1 connector on the upper or right side single-channel Ultra Extender Option card installed in the slave #1 cabinet.

Note: SCSI termination is automatic and requires no user configuration.

11Power on the DEU subsystems. After the power-on self-test has completed, HDD Status and Channel Mode LEDs will be solid green.

12Access the Options menu on the Operator Control Panel and choose the SAFTE CHAIN ID selection. Set the cabinet identities of the master and slave subsystems. Refer to “SAFTE CHAIN ID” described earlier in this Guide.

PRINTER NOTE: Page size 9” x 9.25”. Align this page to top, right hand corner. Back box bleeds off top and right edge. Left side of page extends to 9.25 inches.