Automation and Drives - SCE
3.5.1Startup Using the Basic Operator Panel (BOP)
The Basic Operator Panel (BOP) is available as an option and is used as a display and parameter assignment device. Parameters are set by pressing the keys.
The BOP includes a 5 digit seven segment display on which parameter numbers and parameter values, alarm indications and fault messages as well as setpoint and actual values are shown.
The BOP is able to store parameters, and thus allows for copying parameter sets from one converter to another.
The BOP is attached to the control unit according to the figure below, regardless of the type of control unit.
| Preface | Notes | Startup with PROFIBUS | Startup with PROFINET | Program Example |
|
|
|
|
|
|
T I A Training Document |
| Page 40 of 147 |
| Module | |
|
|
| H01 |
|
|
Issued: 02/2008 |
| Frequency Converter SINAMICS G120 on PROFIBUS DP and PROFINET | |||
