Automation and Drives - SCE
25. Confirm the change of the access path to CP5611[Auto] with ’OK’. (→ OK )
The following access path(s) was/were changed
26.By clicking on '
’, load the configuration table to the PLC. The CPU’s operating mode switch should be on Run! (→ 
)
Note: Make sure your programmer is connected to the CPU via the MPI/PROFIBUS!
|
|
|
|
|
|
|
| Preface | Notes | Startup with PROFIBUS |
| Startup with PROFINET | Program Example |
|
|
|
|
|
|
|
T I A Training Document |
| Page 89 of 147 |
| Module | ||
|
|
| H01 |
|
| |
Issued: 02/2008 |
| Frequency Converter SINAMICS G120 on PROFIBUS DP and PROFINET | ||||
