Automation and Drives - SCE
3.5.2Startup with the Software STARTER using the Connection Kit
Below, the startup of the frequency converter SINAMICS G120 with the software STARTER is described. The PC on which the software STARTER is running has to be connected to the SINAMICS G120 by means of the Connection Kit and a serial interface.
After the parameter assignment was successful, the converter can be controlled with the Basic Operator Panel (BOP).
The buttons are assigned as follows:
Start motor
Stop motor
Reversal
Take motor to the inching mode
Increase speed
Decrease speed
To assign the parameters for the SINAMICS G120, perform the following steps:
1.The parameter assignment tool for the SINAMICS G120 is the ’STARTER’ that is called here with a double click. (→ STARTER)
| Preface | Notes | Startup with PROFIBUS | Startup with PROFINET | Program Example |
|
|
|
|
|
|
T I A Training Document |
| Page 52 of 147 |
| Module | |
|
|
| H01 |
|
|
Issued: 02/2008 |
| Frequency Converter SINAMICS G120 on PROFIBUS DP and PROFINET | |||
