Sonic Alert DCP301 user manual When event type is time event, Display time event

Chapter 8. PROGRAM SETUP

●When event type is time event

(1)In the setting display state, move to the event 1 to 3 items of the segment to be set up on the programming map.

(2)If you press ENT , the upper display starts blinking to indicate start of entry to the No.1 setup.

(3)Press , , or to set to the No.1 setup ON time setting. Setting range: 0:00 to 99:59 (h:min/min:s)

0.0to 599.9 (0.1s)

(Select either of h:min or min:s as the time unit in setup data C 6 4. “:” is substituted by “.” as it cannot be displayed.)

(4)When you press ENT , blinking on the upper display stops. The lower display then starts blinking to indicate start of entry to the No.2 setup.

(When FUNC + CLR are pressed, the upper and lower displays both return to “- - - -” and blinking stops.)

(5)Press , , or to set to the No.2 setup ON time setting.

Setting range: ON time setting + 0:01 to 99:59 (h:min/min:s)

ON time setting + 0.1 to 599.9 (0.1s)

When you press ENT , blinking on the upper display stops.

(6)(When FUNC + CLR are pressed, the upper display returns to “- - - -” and stops blink- ing.)

●Display (time event)

Program No. Segment No.

Pattern

tendency

ON time setting value

OFF time setting value

LEDs corresponding to EV1 to EV3 lit. T1 to T5 all out

•“- - - -” is displayed for the setting values in non-set segments.

•When setup data C 6 8 is set to 1, event 1 to 3 items on the programming map are all skipped and not displayed.

•When the event type is set to time event and the ON time is set to 99:59, “- - - -” is displayed for the ON time and the display does not blink. In this case, the OFF time cannot be set.

•When the event type is set to time event and the ON time is set higher than the time setting of the pattern item, event output at that segment is OFF. However, note that event output is ON when the mode changes to the END mode at segments whose ON time and pattern item time are equal.

●When event type is controller status event

In this case, the event item on the programming map is skipped and not displayed.

8-7