Sonic Alert DCP301 user manual To input

Chapter 7. PARAMETER SETUP

No.	Item Code	Item	Factory	User		Setting
			Setting	Setting
67	C 6 7	Alarm display			0: Display ON
					1: Display OFF
					[Note]
					Even when set to 1, alarm-related events do not
					operate.
68	C 6 8	Programming item:	0		0: Display ON
		Events 1 to 3			1: Display OFF
69	C 6 q	Programming item:	0		[Note]
		Time events 1 to 5			Even if each of the items are set to 1, the function
70	C 7 0	Programming item:	0		operates even if data is set to the program.
		PID set, G.Soak			On models not supporting time events, time event
71	C 7 1	Programming item:	0		items are not displayed in program settings regardless
		PV start, cycle,			of the number of	C 6 q settings.
		pattern link
72	C 7 2	Cold junction	0		0: Compensated internally
		compensation			1: Compensated externally
					[Note]
					When the input 1 range type is other than a thermo-
					couple, “– – – –” is displayed and setting is not
					possible.
73	C 7 3	Input operation at	0		0: Upscale
		input 1 disconnec-			1: Downscale
		tion			[Note]
					This setting is valid when the input 1 range type is
					thermocouple, resistance temperature detector or
					linear (mV series).
74	C 7 4	Voltage time-	0		0: Input ON again enabled within time-proportional cycle
		proportional output			1: Input ON again disabled within time-proportional cycle
		system			[Note]
					When both of outputs 1 and 2 are not voltage time-
					proportional outputs, “– – – –” is displayed and setting
					is not possible.
75	C 7 5	Output 1 selection	Not fixed		0: Current output
76	C 7 6	Output 2 selection	Not fixed		1: Voltage output
					[Note]
					When each of the outputs are relay output, position-
					proportional output, auxiliary output or output is not
					mounted, “– – – –” is displayed and setting is not
					possible.
					Factory setting is 1 if outputs are voltage output
					according to output type. Otherwise, the setting is 0.
77	C 7 7	Unused	—		[Note]
					“– – – –” is displayed and setting is not possible.
78	C 7 8	Voltage output 1	15		2 to 22mA
		adjustment			[Note]
					When each of the outputs are other than voltage output,
79	C 7 q	Voltage output 2	15
		adjustment			“– – – –” is displayed and setting is not possible.
					Normally, use the factory setting.
80	C 8 0	Unused	—		[Note]
					“– – – –” is displayed and setting is not possible.
81	C 8 1	Input 1 burnout cur-	0		0: Burnout current ON
		rent (expansion set-			1: Burnout current OFF
		ting 1)
					[Note]
					Normally set to 0.
					Set to 1 when infra-red thermocouple RT50 is connected
					to input 1.

7-31