Sonic Alert DCP301 user manual Basic Display State Func + Prog keys

Chapter 8. PROGRAM SETUP

●Selecting the program No. after entering program setup (continued)

When you select the program No. by this method, the display changes to segment No.1 and the pattern item on the programming map.

This method can be used, for example, to select a program No. to set up a program other than the No. being operated in the RUN mode. It can also be used to select a program No. to set up a program other than the currently selected No. by external switch input.

■Mode transition

The following diagram shows the transition between modes during program setup.

The following page describes the various mode transition states (1) to (16) in the dia- gram.

Basic Display State

FUNC + PROG keys (1)	DISP
	key (16)
Program setup state		FUNC	+ PROG keys
	key (2)	key (3) FUNC	+	keys (15)

Setting value display state

ENT			ENT		key
key (4)
			FUNC		+	CLR
						keys (10)
DISP	key (11)					DISP
						key (11)
No.1 setting						No.2 setting
entry state	ENT					entry state
			key
	FUNC		+ CLR	keys (6)
key (5)						key (9)
	FUNC	+ CLR		keys (7)
	(pattern item)
Program clear
check state	ENT
			key
“C L R .” blinking
	DISP

key (8)

FUNC + ENT	keys (12)	ENT
(pattern item)		key
		DISP

key (14)

Segment insertion or deletion check state

“I N S .” blinking “d E L .” blinking

key (13)

8-2