
Chapter 8. PROGRAM SETUP
■Setting up pattern link items
(1)In the setting display state, move to the pattern link items on the programming map.
(The settings are common to all segments as the pattern link items are setting items provided for each program.)
(2)If you press ENT , the lower display starts blinking to indicate start of entry to the No.1 setup.
(3)Press ,
,
or
to set to the No.1 setup pattern link setting. Setting range: 0 to 19
0:Pattern link disabled
1to 19: Pattern link destination program No.
(4)When you press ENT , blinking on the lower display stops.
●Display
Program No. |
| Segment No. |
|
|
| P.L I N | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Pattern |
|
|
|
|
|
|
|
|
|
|
|
| Link destination program No. | |
|
| tendency |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
EV1 to EV3 and T1 to T5 all out
•The settings are common to all segments as the pattern link items are setting items provided for each program.
•When setup data C 7 1 is set to 1, pattern link items on the programming map are skipped and not displayed.
■Deleting programs
(1)In the setting display state, move to the pattern item of the segment from which the program is to deleted on the programming map.
To delete all the segments of a particular program, move to the No.1 segment.
(2)If you press ENT , the upper display starts blinking to indicate start of entry to the No.1 setup.
(So far, the procedure is the same as that for setting the pattern item.)
(3)If you press FUNC + CLR , the display changes to confirm clearing of the program, and “C L R .” is displayed blinking in the upper display.
(4)Press ENT to execute deletion of the program.
(5)The DCP301 returns to the setting display state, both the upper and lower displays change to “- - -
●Display
Program No. |
| Segment No. |
| C L R. |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
Pattern
tendency
EV1 to EV3 and T1 to T5 all out
•In the above procedure, FUNC + CLR are pressed while entering values (SP setting value) to the No.1 setup. However, the program can also be deleted by pressing
FUNC + CLR while entering values (time setting value) to the No.2 setup.
•“- - -
•Currently running (RUN, HOLD, FAST, END) programs cannot be deleted.