Standard Horizon GM29 manual AT+CGQMIN Quality of Service Profile Minimum Acceptable, +Cgqmin?

GM29 INTEGRATOR’S MANUAL

6.7 AT+CGQMIN Quality of Service Profile (Minimum Acceptable)

Description	Command	Possible Responses
Set minimum	+CGQMIN=[<cid>	• +CME ERROR: <err>
acceptable	[,<precedence>	• OK
profile	[,<delay> [,<reliability>	• ERROR
	[,<peak>
	[,<mean>]]]]]]
Read the	+CGQMIN?	• +CGQMIN: <cid>,
command		<precedence>, <delay>,
		<reliability>, <peak>,
		<mean>[<CR><LF>+CGQMIN:
		<cid>, <precedence>,
		<delay>, <reliability>, <peak>,
		<mean>[…]]
		• OK
		• ERROR
Test if the	+CGQMIN=?	• +CGQMIN: <PDP_type>, (list of
command is		supported <precedence>s),
supported		(list of supported <delay>s),
		(list of supported <reliability>s)
		, (list of supported <peak>s),
		(list of supported
		<mean>s)[<CR><LF>+CGQMI
		N: <PDP_type>, (list of
		supported <precedence>s),
		(list of supported <delay>s),
		(list of supported <reliability>s)
		, (list of supported <peak>s),
		(list of supported
		<mean>s)[…]]
		• OK
		• ERROR

Allows the TE to specify a minimum acceptable profile which is checked by the MS against the negotiated profile returned in the Activate PDP Context Accept message.

The set command specifies a profile for the context identified by the (local) context identification parameter, <cid>. Since this is the same parameter that is used in the +CGDCONT command, the +CGQMIN command is effectively an extension to the +CGDCONT command.

The QoS profile consists of a number of parameters, each of which may be set to a separate value.

A special form of the set command, +CGQMIN=<cid> causes the minimum acceptable profile for context number <cid> to become undefined. In this case no check is made against the negotiated profile.

<cid>	Description
Integer type	Parameter which specifies a particular PDP context
	definition

116

LZT 123 7361 R1A