Standard Horizon GM29 manual Hscsd Parameters Report, At+Chsr?, At+Chsr=?

GM29 INTEGRATOR’S MANUAL

<wRx>	Description
0	TA/ME shall calculate a proper number of receive
	timeslots from currently selected <wAiur> and <codings>
	See note below
1	Wanted number of receive timeslots is 1
2	Wanted number of receive timeslots is 2
<topRx>	Description
0	Indicates that the user is not going to change <wAiur>
	and /or <wRx> during the next call
1	Top value for <wRx> that user is going to request during
	the next established non-transparent HSCSD call is 1
2	Top value for <wRx> that user is going to request during
	the next established non-transparent HSCSD call is 2
<codings>	Description
4	Indicates that the accepted channel coding for the next
	established non-transparent HSCSD call is 9.6kbit/s only

7.4 AT+CHSR	HSCSD Parameters Report
	Description	Command	Possible Responses
	Set HSCSD parameters	AT+CHSR=[<mode>]	• +CME ERROR: <err>
	reporting on or off		•	OK
			• ERROR
	Show current setting	AT+CHSR?	•	+CHSR: <mode>
			• +CME ERROR: <err>
			• OK
			• ERROR
	Test if command is	AT+CHSR=?	•	+CHSR: (list of
	supported and show			supported
	parameter range			<modes>s)

• +CME ERROR: <err>

• OK

• ERROR

With this command enabled, the intermediate result code +CHSR: <rx>,<tx>,<aiur>,<coding> is returned (from TA to TE) when an HSCSD call is being set up. The result code represents the current (negotiated or renegotiated) HSCSD parameters. If enabled, the intermediate result code is transmitted at the point of the call setup negotiation, where the ME/TA has determined what type of HSCSD connection will be used. Result code transmission is done after possible service (CR), error control (+ER), and/or compression (+DR) reporting,

126

LZT 123 7361 R1A