
GM29 INTEGRATOR’S MANUAL
3.3 ATS2 | Escape Sequence Character |
| |
|
|
|
|
| Description | Command | Possible Responses |
|
|
|
|
| Set escape sequence | ATS2=[<esc>] | • OK |
| character |
| • ERROR |
|
|
|
|
| Read the current | ATS2 | <esc> |
| setting |
|
|
|
|
|
|
| Show if the command | ATS2=? | S2: (list of supported |
| is supported |
| <esc>s) |
|
|
|
|
Defines the character to be used as the escape sequence character when switching from
<esc> | Description |
|
|
43 | Escape sequence character. Default value |
|
|
0 to 255 | Escape sequence character |
|
|
Note! If the <esc> parameter is set to a value in the range of
3.4 ATS3 | Command Line Termination Character | ||
|
|
|
|
| Description | Command | Possible Responses |
|
|
|
|
| Set Command Line | ATS3=<value> | • OK |
| Termination Character |
| • ERROR |
|
|
|
|
| Read the current | ATS3? | <value> |
| setting |
|
|
|
|
|
|
| Show if the command | ATS3=? | S3: (list of supported |
| is supported |
| <value>s) |
|
|
|
|
This
The previous value of S3 is used to determine the command line termination character for entry of the command line containing the S3 setting command. However, the result code issued uses the value of S3 as set during the processing of the command line. For example, if S3 was previously set to 13 and the command line “ATS3=30” is issued,
70
LZT 123 7361 R1A