GM29 INTEGRATOR’S MANUAL
<n> | Description |
|
|
2 | Places all active calls (if any exist) on hold and accepts |
| the other (held or waiting) call |
|
|
2X | Places all active calls on hold, except call X with which |
| communication is supported |
3 | Adds a held call to the conversation |
|
|
4 | Connects the two calls and disconnects the subscriber |
| from both calls (explicit call transfer) |
|
|
“X” is the numbering (starting with 1) of the call given by the sequence of setting up or receiving the calls (active, held or waiting) as seen by the served subscriber. Calls hold their number until they are released. New calls take the lowest available number. Where both a held and a waiting call exists, the above procedures shall apply to the waiting call (i.e. not to the held call) in conflicting situation.
Note! The “directory number” case shall be handled with dial command D, and the END case with hangup command H (or +CHUP).
16.14 AT+CLIP Call Line Identification Presentation
Description | Command | Possible Responses |
|
|
|
Requests calling line | AT+CLIP=<n> | OK |
identification. |
|
|
Read the current | AT+CLIP? | +CLIP: <n>,<m> |
setting |
|
|
|
|
|
Show if the command | AT+CLIP=? | +CLIP: (list of supported |
is supported |
| <n>s) |
|
|
|
This command enables a called subscriber to get the identity of the calling line when receiving a mobile terminated call. The “Set” command enables or disables the presentation of the CLI (calling line identity) at the TE. It has no effect on the execution of the supplementary service CLIP in the network.
When the presentation of the CLI at the TE is enabled (if the calling subscriber has allowed it), the unsolicited result code +CLIP:<number>,<type>,,,<alpha> response is returned after every RING (or +CRING:<type>) result code sent from TA to TE (refer to AT +CRC in section ???????).Whether this will be used when a normal voice call is answered is a
<n> | Description |
|
|
0 | Disables presentation. Default value |
|
|
1 | Enables presentation |
|
|
252
LZT 123 7361 R1A
