10. INTERFACE
10.13 AT+ILRR |
| Cable Interface Local Rate Reporting | ||||
|
|
|
|
|
| |
|
| Description |
| Command | Possible Responses | |
|
|
|
|
|
|
|
|
| Defines |
| AT+ILRR=<value> | • | OK |
|
| character framing |
| • | ERROR | |
|
|
|
|
|
| |
|
| Read the current |
| AT+ILRR? | +ILRR:<value> | |
|
| setting |
|
|
|
|
|
|
|
|
| ||
|
| Show if the command | AT+ILRR=? | +ILRR:(list of supported | ||
|
| is supported |
|
| <values>s) | |
|
| Specifies whether or not the | ||||
|
| information text is transmitted from the DCE to the DTE. The <rate> | ||||
|
| reported shall represent the current (negotiated or renegotiated) DTE- | ||||
|
| DCE rate. If enabled, the intermediate result code is transmitted after | ||||
|
| any modulation, error control or data compression reports are | ||||
|
| transmitted, and before any final result code (e.g. CONNECT) is | ||||
|
| transmitted. The <rate> is applied after the final result code is | ||||
|
| transmitted. |
|
|
|
|
|
|
|
|
|
| |
|
| <value> | Description |
|
| |
|
|
| ||||
|
| 0 | Disables reporting of local port rate (+ILRR: is not | |||
|
|
| transmitted). Default value |
|
| |
| 1 | Enables reporting of local port rate (+ILRR: is transmitted) | ||||
|
|
|
|
| ||
10.14 AT+IPR | Cable Interface Port Command |
|
| |||
|
|
|
|
|
| |
|
| Description |
| Command | Possible Responses | |
|
|
|
|
|
| |
|
| Defines fixed DTE rate | AT+IPR=[rate] | • | OK | |
|
|
|
|
| • ERROR | |
|
|
|
|
|
|
|
|
| Read the current |
| AT+IPR? | • | +IPR:<rate> |
|
| setting |
|
| • | OK |
|
|
|
|
| • ERROR | |
|
| Show if the command | AT+IPR=? | • | +IPR: (), (list of fixed- | |
|
| is supported |
|
|
| only <rate>s)] |
• OK
• ERROR
Specifies the data rate at which the DCE will accept commands, in addition to 1200bits/s or 9600bits/s (as required in v25ter, subclause 4.3). It may be used to select operation at rates used by the DTE, which the DCE is not capable of automatically detecting.
143
LZT 123 7361 R1A