Symantec 10024709 manual See Setting a destination size for the clone switch on

164Command-line switches

Command-line switches

-sze	Sets the size for the destination partitions for either a disk restore or disk copy operation.
	When numbering partitions in the -sze switch, do not include the hidden Ghost partition.
	See “Setting a destination size for the clone switch” on page 169.
-szee	Forces Norton Ghost to keep the sizes of all destination partitions the same as in the source
	partition (no resizing).
	This switch can be used with or without the -clone switch.
	See “Setting a destination size for the clone switch” on page 169.
-szef	Forces Norton Ghost to keep the sizes of all destination partitions, except for the first one,
	the same as in the source partition. The first partition uses the remaining disk space.
	This switch can be used with or without the -clone switch.
	See “Setting a destination size for the clone switch” on page 169.
-szel	Forces Norton Ghost to keep the sizes of all destination partitions, except for the last one,
	the same as in the source partition. The last partition uses the remaining disk space.
	This switch can be used with or without the -clone switch.
	See “Setting a destination size for the clone switch” on page 169.
-tapebuffered	Default tape mode. Sets the ASPI driver to report a read/write as successful as soon as the
	data has been transferred to memory. Useful when using older or unreliable tape devices or
	sequential media.
-tapeeject	Forces Norton Ghost to eject the tape following a tape operation. If the tape drive does not
	support remote ejection you must eject and insert the tape manually before further use.
	Earlier versions ejected the tape by default. By default, Norton Ghost does not eject the
	tape. It rewinds the tape before exiting to DOS.
-tapesafe	Sets the ASPI driver to report a read/write as successful only when the data has been
	transferred to the physical medium. Useful when using older or unreliable tape devices or
	sequential media.
-tapebsize=x	Specifies the tape block size in units of 512 bytes, where x is 1 to 128.
-tapespeed=x	Allows control of tape speed, where x is 0 to F. 0 is the default. 1 to F increase tape speed.
	Only use this when the tape does not work correctly at the speed used by Norton Ghost.
-tapeunbuffered	Sets the ASPI driver to report a read/write as successful only when the data has been
	transferred to the tape drive. (It is possible that this occurs before the data is physically
	written to the medium.)

-tcpm[:slave IP address] The TCP/IP master mode switch causes Norton Ghost to go into TCP/IP master mode automatically, and is the equivalent of selecting TCP/IP Master from the main menu. The IP address of the slave computer may be specified. See “Peer-to-peer connections” on page 178.