
4220 Flow Meter Section 6 Maintenance and Service
6.4Maintenance of the Printer
The internal printer needs little maintenance beyond changing the chart roll and the ink ribbon.
Refer to the pictures provided for each section. Also refer to the label inside the cabinet.
END CAP
REROLL SPOOL |
| |
ASSEMBLY | SUPPLY SPOOL | |
END CAP | ||
ASSEMBLY |
1.REMOVE REROLL AND SUPPLY ASSEMBLIES, AND REMOVE WHITE CAPS.
2.PLACE EMPTY SPOOL ON REROLL ASSEMBLY AND NEW SPOOL ON SUPPLY ASSEMBLY. REPLACE BOTH END CAPS.
3.FOLD END OF NEW PAPER AS SHOWN AND REINSTALL SUPPLY ASSEMBLY.
4.INSERT PAPER END INTO PLOTTER ENTRANCE (MARKED BY ARROW ON PLOTTER) AND PRESS CHART ADVANCE.
5.ADVANCE PAPER SO SEVERAL INCHES EXTEND FROM PLOTTER.
6.REINSTALL REROLL ASSEMBLY AND TAPE END OF PAPER TO EMPTY SPOOL.
Figure 6-4 Changing the Chart Paper
6.4.1Changing the Roll of Paper
To change the chart paper you will need:
•a new roll of paper
•a knife or a pair of scissors
•a small piece of tape
The printer will shut down when the paper runs out. The roll is nearly empty when a
To remove the used roll:
1.Locate the handle on the left side of the
2.Pull straight out on this handle until the
3.Remove the paper roll from the
4.Snap the white end cap free from the two black catches on the end of the spool.
5.Pull the paper roll off the spool with your other hand.