Texas Instruments TMS320C674X manual Broadcast Transmit Frames Register TXBCASTFRAMES

EMAC Module Registers www.ti.com

5.50.15 Broadcast Transmit Frames Register (TXBCASTFRAMES)

The total number of good broadcast frames transmitted on the EMAC. A good broadcast frame is defined as having all of the following:

•Any data or MAC control frame destined for address FF-FF-FF-FF-FF-FFh only

•Was of any length

•Had no late or excessive collisions, no carrier loss, and no underrun

5.50.16 Multicast Transmit Frames Register (TXMCASTFRAMES)

The total number of good multicast frames transmitted on the EMAC. A good multicast frame is defined as having all of the following:

•Any data or MAC control frame destined for any multicast address other than FF-FF-FF-FF-FF-FFh

•Was of any length

•Had no late or excessive collisions, no carrier loss, and no underrun

5.50.17 Pause Transmit Frames Register (TXPAUSEFRAMES)

The total number of IEEE 802.3X pause frames transmitted by the EMAC. Pause frames cannot underrun or contain a CRC error because they are created in the transmitting MAC, so these error conditions have no effect on this statistic. Pause frames sent by software are not included in this count. Since pause frames are only transmitted in full-duplex mode, carrier loss and collisions have no effect on this statistic.

Transmitted pause frames are always 64-byte multicast frames so appear in the multicast transmit frames register and 64 octect frames register statistics.

5.50.18 Deferred Transmit Frames Register (TXDEFERRED)

The total number of frames transmitted on the EMAC that first experienced deferment. Such a frame is defined as having all of the following:

•Was any data or MAC control frame destined for any unicast, broadcast, or multicast address

•Was any size

•Had no carrier loss and no underrun

•Experienced no collisions before being successfully transmitted

•Found the medium busy when transmission was first attempted, so had to wait.

CRC errors have no effect on this statistic.

5.50.19 Transmit Collision Frames Register (TXCOLLISION)

The total number of times that the EMAC experienced a collision. Collisions occur under two circumstances:

•When a transmit data or MAC control frame has all of the following:

–Was destined for any unicast, broadcast, or multicast address

–Was any size

–Had no carrier loss and no underrun

–Experienced a collision. A jam sequence is sent for every non-late collision, so this statistic increments on each occasion if a frame experiences multiple collisions (and increments on late collisions).

•When the EMAC is in half-duplex mode, flow control is active, and a frame reception begins.

CRC errors have no effect on this statistic.

128	EMAC/MDIO Module	SPRUFL5B –April 2011
		Submit Documentation Feedback

© 2011, Texas Instruments Incorporated