Texas Instruments TMS320C674X manual Mdio User Access Register 1 USERACCESS1

www.ti.com MDIO Registers

4.13 MDIO User Access Register 1 (USERACCESS1)

The MDIO user access register 1 (USERACCESS1) is shown in Figure 37 and described in Table 35.

Figure 37. MDIO User Access Register 1 (USERACCESS1)

31	30	29	28	26	25	21	20	16
GO	WRITE	ACK		Reserved	REGADR			PHYADR
R/W1S-0	R/W-0	R/W-0		R-0	R/W-0			R/W-0
15								0

DATA

R/W-0

LEGEND: R/W = Read/Write; R = Read only; W1S = Write 1 to set (writing a 0 has no effect); -n= value after reset

Table 35. MDIO User Access Register 1 (USERACCESS1) Field Descriptions

Bit	Field	Value	Description
31	GO	0-1	Go bit. Writing 1 to this bit causes the MDIO state machine to perform an MDIO access when it is
			convenient for it to do so; this is not an instantaneous process. Writing 0 to this bit has no effect.
			This bit is writeable only if the MDIO state machine is enabled. This bit will self clear when the
			requested access has been completed. Any writes to USERACCESS0 are blocked when the GO
			bit is 1.
30	WRITE		Write enable bit. Setting this bit to 1 causes the MDIO transaction to be a register write; otherwise,
			it is a register read.
		0	The user command is a read operation.
		1	The user command is a write operation.
29	ACK	0-1	Acknowledge bit. This bit is set if the PHY acknowledged the read transaction.
28-26	Reserved	0	Reserved
25-21	REGADR	0-1Fh	Register address bits. This field specifies the PHY register to be accessed for this transaction
20-16	PHYADR	0-1Fh	PHY address bits. This field specifies the PHY to be accessed for this transaction.
15-0	DATA	0-FFFFh	User data bits. These bits specify the data value read from or to be written to the specified PHY
			register.

SPRUFL5B –April 2011	EMAC/MDIO Module	81
Submit Documentation Feedback

© 2011, Texas Instruments Incorporated