Administration
Using the CLI
To download software from a TFTP/FTP Server, use the copy command from the Exec mode. The copy command requires you to specify either the file type and then the server type, or the server type and then the file type. You must then specify the file name, and IP address of the TFTP server. When the download is complete, you can use the dir command to check that the new file is present in the access point file system. To run the new software, use the reset board command to reboot the access point.
RoamAbout 3000#
RoamAbout 3000#copy tftp file
1.Application image
2.Config file
3.Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file
TFTP Server IP:196.192.18.1
FTP Username:[admin]:
FTP Password:[password]:
RoamAbout 3000#copy ftp file
1.Application image
2.Config file
3.Boot block image
Select the type of download<1,2,3>: [1]:2 FTP Source file name:ets_310.cfg
FTP Server IP:10.2.20.140 FTP Username:[admin]: FTP Password:[password]:
The configuration file was properly copied over to the system but a later setup command will override the file. A reset is needed in order for the configuration file changes to take place.
RoamAbout 3000#reset board Reboot system now? <y/n>: y
RoamAbout Access Point 3000 Configuration Guide
