Command Groups
pppoe ip allocation mode
This command specifies how IP addresses for the PPPoE tunnel are configured on this interface.
Syntax
pppoe ip allocation mode {automatic static}
•automatic ‐ IP addresses are dynamically assigned by the ISP during PPPoE session initialization.
•static ‐ Fixed addresses are assigned by the ISP for both the local and remote IP addresses.
Default Setting
automatic
Command Mode
Interface Configuration (Ethernet)
Command Usage
The IP address allocation mode depends on the type of service provided by the ISP. If the ISP uses DHCP to allocate dynamically the IP addresses for the PPPoE connection, select automatic mode. If the ISP has assigned static addresses, select static and then enter the static addresses using the pppoe local ip and pppoe remote ip commands.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout
RoamAbout
Related Commands
pppoe local ip page A‐51 pppoe remote ip page A‐52
RoamAbout Access Point 3000 Configuration Guide
