RADIUS
Using Web Management
Select RADIUS from the menu.
Configure the following settings to use RADIUS authentication on the access point:
•IP Address/Server Name specifies the IP address or host name of the RADIUS server. The IP address must be an IP Version 4 address.
•Port Number is the UDP port number used by the RADIUS server for authentication. This value must match the configuration of your primary RADIUS authentication server. Range: 1024‐65535; Default: 1812
•Key is the shared text string used to encrypt messages between the access point and the RADIUS server. Be sure that the same text string is specified on the RADIUS server. Do not use blank spaces in the string. Maximum length: 255 characters
•Timeout (seconds) is the number of seconds the access point waits for a reply from the RADIUS server before re‐sending a request. Range: 1‐60 seconds; Default: 5
•Retransmit attempts is the number of times the access point tries to re‐send a request to the RADIUS server before authentication fails. Range: 1‐30; Default: 3
Note: For the Timeout and Retransmit attempts fields, accept the default values unless you experience problems connecting to the RADIUS server over the network.
•RADIUS Accounting enables or disables the AP to send RADIUS accounting information for clients to the RADIUS accounting server. Default: Disable
•Accounting Port specifies the specific destination port for RADIUS accounting packets. A value between 1024 and 65535. This value must match the configuration of your primary RADIUS accounting server. Default: 1813
