Command Groups
pppoe lcp echo-failure
This command sets the Link Control Protocol (LCP) echo timeout for the PPPoE tunnel.
Syntax
pppoe lcp
timeout is the number of timeouts allowed. Range: 1‐10
Default Setting
3
Command Mode
Interface Configuration (Ethernet)
Command Usage
Echo requests are used to verify the integrity of the link through the PPPoE tunnel. Devices at either end of the link can issue an echo‐request. Devices receiving an echo‐request must return an echo‐reply.
If a link is busy with large data transfers, the echo‐reply may not be issued in a timely manner causing the link to timeout. If you experience this kind of problem, try extending the echo interval or timeout.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout
RoamAbout
Related Commands
pppoe lcp echo‐interval page A‐49
