Filter Control
Using the CLI
CLI Commands for VLAN Support
From the global configuration mode, use the management‐vlanid command to set the default Management VLAN ID for the Ethernet interface, then enable management VLAN tagging using the management‐vlan enable command (use no management‐vlan to disable). When you change the access point’s management VLAN setting, you must reboot the access point to implement the change. To view the current management VLAN settings, use the show system command.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout
RoamAbout
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 3000#show system
System Information
====================================================================
Serial Number | : 034830992141 | |
System Up time | : 0 days, 5 hours, 8 minutes, 42 seconds | |
System Name | : RoamAbout AP | |
System Location | : |
|
System Contact | : |
|
System Country Code | : US - UNITED STATES | |
Ethernet MAC Address : | ||
802.11a MAC Address | : | |
|
| |
|
| |
|
| |
802.11b/g MAC Address : | ||
|
| |
|
| |
IP Address |
| |
: 10.2.43.203 | ||
Subnet Mask | : 255.255.0.0 | |
Default Gateway | : 10.2.1.1 | |
Management VLAN State: ENABLED | ||
Management VLAN ID(AP: | 3 | |
IAPP State | : | ENABLED |
DHCP Client | : | DISABLED |
HTTP Server | : | ENABLED |
HTTP Server Port | : | 80 |
HTTPS Server | : | ENABLED |
HTTPS Server Port | : | 443 |
Slot Status | : | Dual band(a/g) |
SSH Server | : | ENABLED |
SSH Server Port | : | 22 |
Telnet Server | : | ENABLED |
Com Port | : | ENABLED |
Software Version | : | V3.1.0 |
====================================================================
RoamAbout 3000#
RoamAbout Access Point 3000 Configuration Guide