Filter Control
•Management VLAN ID specifies the management VLAN ID for the access point.
The management VLAN is for managing the access point. For example, the access point allows traffic that is tagged with the specified VLAN to manage the access point via remote management, SSH, SNMP, Telnet, etc.
•Management VLAN allows you to enable or disable management VLAN tagging support on the Access Point 3000. Default: Disable
•Ethernet Untagged VLAN ID specifies the VLAN ID to which the AP maps untagged packets entering through the APʹs Ethernet port. Range: 1 to 4094
•IAPP (Inter Access Point Protocol) enables the protocol signaling required for wireless clients to roam between different 802.11f‐compliant access points. Select Disable to disable 802.11f signaling. Default: Enable.
•IBSS Relay Control, in conjunction with radio interface and Virtual AP (VAP) IBSS settings, controls whether clients associated with an interface or VAP can establish wireless communications with clients associated with other interfaces or VAPs. Default: All VAP mode
–In All VAP Mode, clients associated with any IBSS enabled radio interfaces or VAPs can establish wireless communications with each other.
–In Per VAP Mode, clients associated with a specific IBSS enabled radio interface or VAP can establish wireless communications with other clients associated with the same interface or VAP. For example, clients associated with VAP1 can establish wireless communications with each other but not with clients associated with an IBSS enabled VAP2.
•Wireless AP Management controls management access to the Access Point 3000 from wireless clients. Management interfaces include the Web, Telnet, or SNMP. Default: Allow
–Allow permits management access from wireless clients. The default setting.
–Disallow blocks management access from wireless clients.
•Ethernet Type Filter controls checks on the Ethernet type of all incoming and outgoing Ethernet packets against the protocol filtering table. Default: Disable
–Disable: The access point does not filter Ethernet protocol types.
–Enable: The access point filters Ethernet protocol types based on the configuration of protocol types in the filter table. If a protocol has its status set to “ON,” in the filter table, the access point filters that protocol.
–Local Management lists the Ethernet protocols.
–ISO Designator specifies the ISO designators for each Ethernet protocol listed.
–Status indicates, by radio button selection, whether the access point filters this Ethernet protocol. ON indicates filtering for this Ethernet protocol. Off indicates no filtering for this Ethernet protocol.
