Enterasys Networks 9033900-04 manual Qos mode

Command Groups

qos mode

This command allows you to set the type of classification used by the access point based on the source address (SA), destination address (DA), Ethernet type, or 802.1p.

Syntax

qos mode <mode>

mode is the type of classification used by the access point (SA, DA, Ether‐type, or 802.1p)

Default Setting

None

Command Mode

Global Configuration

Command Usage

•After you select SA or DA, use the qos mac-addrcommand to enter the MAC addresses and the priority.

•After you select Ether‐type, use the qos ether-typecommand to enter the Ethernet protocol type and the priority.

•If you select 802.1p, the priorities are based on the device (switch) attached. No further configuration is necessary.

Example

RoamAbout 3000#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 3000(config)#qos mode SA

RoamAbout 3000(config)#

RoamAbout Access Point 3000 Configuration Guide A-155