Enterasys Networks 9033900-04 manual Table A-16 QoS Commands Function Mode

Command Groups

QoS Commands

When you configure QoS (Quality of Service) on the access point, you can select specific network traffic, prioritize it, and use congestion‐management and congestion‐avoidance techniques to provide preferential treatment. Implementing QoS in your wireless LAN makes network performance more predictable and bandwidth utilization more effective.

Eight classes are defined for the priority. Network managers determine actual mappings. The highest priority is seven and the lowest priority is 0. For example, if you select 5 as the priority, 5 receives higher priority than those set with 0, 1, 2, 3, or 4 and lower priority than those set with 6 and 7 as their priority.

Use the commands described in Table A‐16 to configure QoS parameters.

Table A-16 QoS Commands

Command	Function	Mode	Page
qos mode	Sets classifications by which to set	GC	A-155
	priorities.
qos mac-addr	Sets priorities for up to ten MAC	GC	A-156
	addresses when using source or
	destination addresses to classify QoS.
qos ether-type	Sets priorities for up to ten Ethernet	GC	A-156
	types when using Ethernet type to
	classify QoS.
svp	Enables or disables Spectralink Voice	GC	A-157
	Priority (SVP) status
show svp	Displays status of SVP	Exec	A-157

A-154