Enterasys Networks 9033900-04 manual Snmp-server targets

Command Groups

snmp-server targets

This command configures SNMP v3 notification targets. Use the no form to delete an SNMP v3 target.

Syntax

snmp-server targets <target-id><ip-addr><sec-name> [version {3}] [udp-port {port-number}][notify-type {TRAP}]

no snmp-server targets <target-id>

•target‐id is the user‐defined name that identifies a receiver of SNMP notifications. (Maximum length: 32 characters)

•ip‐addr specifies the IP address of the management station to receive notifications.

•sec‐name is the defined SNMP v3 user name that is to receive notifications.

•version is the SNMP version of notifications. Currently only version 3 is supported in this command.

•port‐number is the UDP port that is used on the receiving management station for notifications.

Default Setting

None

Command Mode

Global Configuration

Command Usage

The SNMPv3 user name that is specified in the target must first be configured using the snmp-server user command.

Example

RoamAbout 3000#configure

Enter configuration commands, one per line. End with CTRL/Z RoamAbout 3000(config)#snmp-server targets mytraps 192.168.1.33 dave RoamAbout 3000(config)#

RoamAbout Access Point 3000 Configuration Guide A-69