Enterasys Networks 9033900-04 - page 25

Initial Configuration Steps
RoamAbout Access Point 3000 Configuration Guide 3-3
5. IfyouraccesspointusesaDHCPassignedIPaddressgoontochangethedefaultusername
andpassword.
Otherwise,disableDHCPforthisaccesspointasfollows:
a. Typeconfiguretoenterconfigurationmode.
b. TypeinterfaceethernettoaccesstheEthernetinterfaceconfigurationmode.
c. DisableDHCP.Typenoipdhcp.
d. SettheIPAddress.Typeipaddressip‐addressnetmaskgateway,whereip‐addressisthe
accesspoint’sIPaddress,netmaskisthenetworkmaskforthenetwork,andgatewayis
thedefaultgatewayrouter.CheckwithyoursystemadministratortoobtainanIPaddress
thatiscompatiblewithyournetwork.
Afterconfiguringtheaccesspoint’sIPparameters,youcanaccessthemanagement
interfacefromanywherewithintheattachednetwork.Thecommandlineinterfacecan
alsobeaccessedusingTelne tfromanycomputerattachedtothenetwork.
6. Changethedefaultusernameandpassword:typeusernameandspecifyauniqueusername;
typepasswordandspecifyauniquepassword.
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#
RoamAbout 3000(if-ethernet)#no ip dhcp
DHCP client state has changed. Please reset AP for change to take effect.
RoamAbout 3000(if-ethernet)#exit
RoamAbout 3000#reset board
Reboot system now? <y/n>: y
Username: admin
Password:********
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#
RoamAbout 3000(if-ethernet)#ip address ip-address netmask gateway
RoamAbout 3000(if-ethernet)#end
RoamAbout 3000(config)#
RoamAbout 3000(config)#username JadaPerl
RoamAbout 3000(config)#password G7nq1Z
Confirm new password: G7nq1Z
RoamAbout 3000(config)#