
Command Groups
ip dhcp
This command sets the IP address for the access point. Use the no form to restore the default IP address.
Syntax
ip dhcp no ip dhcp
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
•You must assign an IP address to this device to gain management access over the network or to connect the access point to existing IP subnets. You can manually configure a specific IP address using the ip address command, or direct the device to obtain an address from a DHCP server using this command.
•When you use this command, the access point will begin broadcasting DHCP client requests. The current IP address (i.e., default or manually configured address) will continue to be effective until a DHCP reply is received. Requests will be broadcast periodically by this device in an effort to learn its IP address. (DHCP values can include the IP address, subnet mask, and default gateway.)
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line. RoamAbout
DHCP client state has changed. Please reset AP for change to take effect. RoamAbout
RoamAbout 3000#reset board Reboot system now? <y/n>: y Username: admin Password:******** RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line. RoamAbout
Related Commands
ip address page A‐119
RoamAbout Access Point 3000 Configuration Guide