Enterasys Networks 9033900-04 manual Native-vlanid

Command Groups

native-vlanid

This command configures the native VLAN ID for the access point radio interfaces.

Syntax

native-vlanid <vlan-id>

vlan‐id is the native VLAN ID. Range: 1‐4094

Default Setting

1

Command Mode

Interface Configuration (Wireless)

Interface Configuration (Wireless): VAP

Command Usage

•Use this command for the default interface or any of the seven VAPs configurable per radio interface.

•To implement the native VLAN ID setting for each radio interface, you must enable VLAN support on the access point using the vlan command.

•When VLANs are enabled, the access point tags frames received from wireless clients with the native VLAN ID for the radio interface. If IEEE 802.1x is being used to authenticate wireless clients, specific VLAN IDs can be configured on the RADIUS server to be assigned to each client. Using IEEE 802.1x and a central RADIUS server, up to 64 VLAN IDs can be mapped to specific wireless clients.

•If the VLAN ID has not been configured for a client on the RADIUS server, then the frames are tagged with the native VLAN ID of the radio interface.

Example

The following example shows setting the native VLAN ID for the default interface and a VAP.

RoamAbout 3000#configure

Enter configuration commands, one per line. End with CTRL/Z

RoamAbout 3000(config)#interface wireless a

RoamAbout 3000(if-wireless a)#native-vlanid 3

RoamAbout 3000(if-wireless a)#vap 6

RoamAbout 3000(if-wireless a: VAP[6])#native-vlanid 30

RoamAbout 3000(if-wireless a: VAP[6])#end

RoamAbout 3000(if-wireless a)#

Related Commands

vlan page A‐174

RoamAbout Access Point 3000 Configuration Guide A-175