
Command Groups
ip address
This command sets the IP address for the (10/100Base‐TX) Ethernet interface. Use this command to set the IP address for the access point when not setting the IP address from a DHCP server. Use the no form to restore the default IP address.
Syntax
ip address
•ip‐address is the IP address
•netmask is the network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets
•gateway is the IP address of the default gateway
Default Setting
IP address: 192.168.1.1
Netmask: 255.255.255.0
Command Mode
Interface Configuration (Ethernet)
Command Usage
•You must assign an IP address to this device to gain management access over the network or to connect the access point to existing IP subnets. You can manually configure a specific IP address using this command, or direct the device to obtain an address from a DHCP server using the ip dhcp command. Valid IP addresses consist of four numbers, 0 to 255, separated by periods. Anything outside this format will not be accepted by the configuration program.
•DHCP is enabled by default. To manually configure a new IP address, you must first disable the DHCP client with the no ip dhcp command.
RoamAbout Access Point 3000 Configuration Guide