Command Groups
pppoe lcp echo-interval
This command sets the Link Control Protocol (LCP) echo interval for the PPPoE tunnel.
Syntax
pppoe lcp
interval is the interval between sending echo requests. Range: 1‐60 seconds
Default Setting
10
Command Mode
Interface Configuration (Ethernet)
Command Usage
•Echo requests are used to verify the integrity of the link through the PPPoE tunnel. Devices at either end of the link can issue an echo‐request. Devices receiving an echo‐request must return an echo‐reply.
•If a link is busy with large data transfers, the echo‐reply may not be issued in a timely manner causing the link to timeout. If you experience this kind of problem, try extending the echo interval or timeout.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout
RoamAbout
Related Commands
pppoe lcp echo‐failure page A‐50
RoamAbout Access Point 3000 Configuration Guide
