Enterasys Networks 9033900-04 manual PPPoE Commands, Show version

Command Groups

show version

This command displays the software version for the system.

Default Setting

None

Command Mode

Exec

Example

RoamAbout 3000#show version

Version v2.6.7

RoamAbout 3000#

PPPoE Commands

The commands described in this section configure PPPoE (Point‐to‐Point Protocol over Ethernet) management tunnel connection parameters for the Ethernet port.

Table A-8 PPPoE Commands

Command	Function	Mode	Page
ip pppoe	Enables PPPoE on the Ethernet interface	IC-E	A-46
pppoe ip allocation	Specifies how IP addresses for the PPPoE	IC-E	A-47
	tunnel are configured on the interface
pppoe ipcp dns	Negotiates DNS for the PPPoE tunnel	IC-E	A-48
pppoe lcp echo-interval	Sets LCP echo interval for the PPPoE tunnel	IC-E	A-49
pppoe lcp echo-failure	Sets LCP echo timeout for the PPPoE tunnel	IC-E	A-50
pppoe local ip	Sets local IP address for the PPPoE tunnel	IC-E	A-51
pppoe remote ip	Sets remote IP address for the PPPoE tunnel	IC-E	A-52
pppoe username	Sets the user name for the PPPoE tunnel	IC-E	A-53
pppoe password	Sets the password for the PPPoE tunnel	IC-E	A-54
pppoe service-name	Sets the service name for the PPPoE tunnel	IC-E	A-55
pppoe restart	Restarts the PPPoE connection with updated	IC-E	A-55
	parameters
show pppoe	Shows information about the PPPoE	Exec	A-56
	configuration

RoamAbout Access Point 3000 Configuration Guide A-45