SERVICE PROGRAM TABLES April, 2007

5-20

5.5 SERVICE PROGRAM TABLES

5.5.1 SERVICE TABLE KEY

Notation What it means
[range/step] Example: [–9 to +9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen in
the “Initial” box immediately below the entry box.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
LEF Long Edge Feed
SEF Short Edge Feed