Printing
4.Insert all media faceup and top edge first into the paper tray. Notes:
•Do not force the paper into the tray.
•Be careful not to bend the paper.
5.Slide the paper width guides until they rest lightly against the edge of the paper stack.
Note: When Size Mismatch (in the PCL driver’s Advanced tab, or in the PostScript driver’s Details section in the Advanced tab) is set to Use Printer Settings, you must set the paper type and size for the tray you intend to use on the printer control panel in advance.
6.Insert the tray back into the printer until it stops.
Caution: Be careful not to use excessive force on the tray. Doing so could damage the printer.
See also:
Setting Paper Types and Sizes on page 62
Loading Paper in the Manual Feed Slot
Use the manual feed slot for a wide range of media including:
•Plain paper
•Thin card stock
•Glossy paper (Coated 2 and Coated 3)
•Labels
•Envelopes
For a more complete list of paper types and sizes usable in the Manual Feed Slot, see Usable Paper on page 52.
To avoid problems during printing, make sure of the following points:
•Use several sheets of the media only when adjusting the paper width guides.
•Holding the media on both sides, slowly and evenly insert the media into the printer.
•If the media looks skewed after the printer pulls it in, gently remove the media and reseat it. Then press the OK button or wait for the automatic calibration to start.
Phaser 6140 Color Laser Printer | 57 |
User Guide |
|
